2310 818352  Βούλγαρη 73  lyre@orpheusaudio.gr

LYRA Etna λ Lambda SL

LYRA Etna λ Lambda SL

This is a special, built-to-order, version of Etna for expert users with very high-gain, extra low noise phono stages, or alternatively a step-up transformer designed for phono cartridges of 2 – 3 ohms or less.
Most users (and phono stages) will benefit from the regular Etna with much higher output and considerably more energy; resulting in a much better signal-to-noise ratio. If you are in doubt about which version of Etna that will work best in your system, please go with the regular Etna.

Επικοινωνήστε μαζί μας για περισσότερες πληροφορίες

Επικοινωνήστε μαζί μας

Specifications For Etna Lambda SL

• Designer: Jonathan Carr
• Builder: Yoshinori Mishima (final build, testing), Akiko Ishiyama (preliminary build)
• Type: Medium weight, medium compliance, low-impedance, low-output moving coil cartridge
• Stylus: Lyra-designed long-footprint variable-radius line-contact nude diamond (3um x 70um profile, block dimensions 0.08 x 0.12 x 0.5mm), slot-mounted
• Cantilever system: Diamond-coated solid boron rod with short one-point wire suspension, directly mounted into cartridge body via high-pressure knife-edge system
• Coils: 2-layer deep, 6 N high-purity copper, chemically-purified high purity iron X-shaped former, 1.52 ohm self-impedance, 1.9μH inductance
• Output voltage: 0.25 mV@5 cm/sec., zero to peak, 45 degrees (CBS test record, other test records may alter results)
• Frequency range: 10 Hz-50 kHz
• Channel separation: 35 dB or better at 1 kHz
• Compliance: Approx. 12 X10 cm/dyne at 100 Hz
• Vertical tracking angle: 20 degrees

 

http://www.lyraconnoisseur.com/Products/Products_Analog/Etna/etna_sl.html

0
    0
    Το καλάθι σας
    Το καλάθι είναι άδειοΕπιστοφή στο κατάστημα